3 ton steam boiler for steam distillation

After the boiler put into use, such as the hotel responsible person to give us feedback: fast boiler advanced product design, simple and intuitive operation, the most critical is energy saving, low NOx emissions, can be used in the Beijing area. Compared with other boiler brands, fast Boiler made us worry. --customer feedback

Why should the heating surface of boiler soot-blowing? A: soot-blowing is to keep the heating surface cleaning. Due to the small thermal conductivity ash, boiler heating surface fouling, affect the heat transfer of the heating surface, the temperature of the endothermic working fluid drops, the exhaust gas temperature rises, thereby reducing the thermal efficiency of the boiler; severe fouling, the flue gas flow reduced cross-sectional area, the flow resistance increases, increasing the wind electrical energy consumption, reduce the load of the boiler operation, even forced shutdown; fouling since the rear smoke temperature rise, the tail affect the safe operation of heating surface. Local severe fouling, it is possible to form a "smoke corridor", the local speed increase of smoke due to the heating surface, increased wear. It should periodically heating surface boiler soot blowing.

Good safety performance is the basis for normal and stable operation of the industrial boilers. Just boiler explosion occurred this year has been more than 10 cases, economic and personal security have caused serious and irreversible adverse effects. Boiler itself belongs to special equipment, the internal pressure, once the abnormal fault occurs, the consequences could be disastrous.

Single large boiler load adjustment flexibility is poor, and most are coarse adjustment by artificially staged by "the size of the fire", "top fire" or the realization. From the outside weather conditions change frequently, the larger the magnitude of the initial heating, adjust the end of the performance, the traditional boiler boiler unit determines the actual output is difficult to match the actual load required, often resulting in less heat and overheating occurs, that is often said the "supply and demand" so unnecessary additional excessive heat loss while the deterioration of the quality of the heating. In accordance with relevant domestic literature of statistics, domestic fuel, overall load factor in gas heating boiler (includes backup device), the thermal efficiency is maintained at most 45%, 72.7%, and this is very uneconomical, but this has not been caused by two indicators Experts attention. According to the advanced standards in terms of energy above the boiler system comprehensive utilization rate is also very low.